wma 280 datasheet0 pages
WMA-280
DC – 100kHz High Voltage Amplifier WMA-280
www.falco-systems.com
www.falco-systems.com
falco
-150V to +150V output
DC to 100kHz at -3dB full
power bandwidth
300µVrms output noise only
Precision amplifier:
20x ±0.1% amplification and both
BNC and differential input
±300mA Output current limit
Short-circuit protected
output
For MEMS devices, EOmodulators, PZT (piezo)
positioning, beam steering,
ultrasonic systems, …
The Falco Systems WMA-280 is a low noise, precision
The amplifier has both a standard BNC and a differential
high
demanding
input with a Thomas & Betts multi-pole connector. The
applications. Its good voltage precision, low output noise
latter can be used when lowest noise and interference
and large voltage range make it an excellent choice when
performance is required (the amplifier comes with a contra-
high precision is important. It can be used for precise
connector for easy interfacing to other equipment). The 20x
positioning of MEMS devices, with EO-modulators, PZT
amplification is accurate to within 0.1%.
(piezo)
Output overload or short-circuit conditions are no problem,
voltage
laboratory
driver
positioning
amplifier
for
systems,
beam
steering
components, ultrasonics, and many more.
due to the extremely fast output current limiting circuit that
The offset and noise specifications of this amplifier are
has been employed. The amplifier is suitable for capacitive
such, that with typical electrostatically actuated MEMS or
resistive loads.
as piezo driver, a positioning accuracy of sub-atomic
dimensions can be easily achieved.
0.28
Integrated noise (mV rms)
Output amplitude (Volt)
300
250
200
150
100
50
0.26
0.24
0.22
0.20
0.18
0.16
0.14
0.12
0
2
10
1
2
10
3
10
10
4
5
10
6
10
10
3
10
4
10
5
10
Frequency (Hz)
Frequency (Hz)
Frequency response (300Vpp)
Integrated output noise spectrum
6
10
"