Emitter EM0 pages

Stereoscopic Width Gauge Stereoscopic Width Gauge XD1000 table.main {} tr.row {} td.cell {} div.block {} div.paragraph {} .font0 { font:6.00pt "Arial", sans-serif; } .font1 { font:7.00pt "Arial", sans-serif; } .font2 { font:8.00pt "Arial", sans-serif; } .font3 { font:12.00pt "Arial", sans-serif; } .font4 { font:36.00pt "Arial", sans-serif; } .font5 { font:40.00pt "Arial", sans-serif; } .font6 { font:12.00pt "Microsoft Sans Serif", sans-serif; } r Light Emitter Emitter EM Applications The light Emitter EM is used in association with linear camras : DR, TSP, for applications such as : Width measurement Centerline measurement Edge position measurement Cold bars detection Weld hole detection Strip loop measurement General description The Emitter EM uses a fluorescent tube and a high frequency electronic ballast to generate light modulation at 28 kHz. The use of a high frequency tube results in constant light conditions as regards to the minimum exposure time of the sensors DR, TSP. This is important in order to avoid 100 Hz (or 120 Hz) over modulation problems associated with standard tubes. Technical Characteristics Rf驩rence EM 500 EM 500-PL EM 1100 EM 1100-PL EM 1400 EM 1400-PL Emission length (mm) 500 1100 1400 Emission width 25 mm Power 25 W 50 W 70 W Supply voltage 220 V (-10%) to 240 V (+10%) - 50 or 60 Hz Operating temperature -15 °C to 70 °C (5 °F to 160 °F) Housing Metallic Protection rating IP 66 ISO 9001 E 3022 DELTA - Aroparc 2 - 12 rue des Cigognes - 67960 ENTZHEIM - FRANCE - TEL : +33 388 78 21 01 FAX : +33 388 76 02 29 - www.deltasensor.eu