MicroVantage MAS Series - General Grade0 pages

MicroVantage™ MAS-G Series
General Grade Polyethersulfone Membrane Filter Cartridges
•t Absolute retention ratings from 0.03 to 1.2 microns
•t 7.2 square feet (0.67 m2) of media surface area per ten inch
length for high throughput and longer service life
•t Fully integrity tested to ensure reliable performance in critical
applications
•t 100% flushed with 18 megohm DI water for low extractables
•t Manufactured in a Class 10,000 Clean Room environment for
high purity
•t Polypropylene hardware offers wide range of chemical
compatibility
•t Rigid, molded cage protects pleated media and strengthens
structural stability
•t Complies with Food & Drug Administration’s CFR criteria for
food & beverage contact
•t Meets USP Class VI Biological Test for plastics
•t Available in standard lengths and end cap configurations to fit
most filter housings
•t Produced up to 40 inches in length (10 inch modules)
Applications
RO Pre/Post Filtrationtt
DI Watertttt
Plating Solutionsttt
Specialty Chemicalstt
Water & Wastewatertt
Specifications & Operating Parameters
Food & Beverage
Bottled Water
Microelectronics
Process Water
Cosmetics
Pore Sizes 0.03, 0.1, 0.2, 0.45, 0.65, 0.8, 1.0 and 1.2 microns
absolute retention
Maximum Operating Temperature 176°F ( 80°C)
Nominal Lengths 9.75" (24.7 cm), 10" (25.4 cm), 20" (50.8 cm),
35 psid (2.4 bar)
30" (76.2 cm), 40" (101.6 cm)
Outside Diameter 2.67" (6.78 cm)
Inside Diameter 1.0" (2.54 cm)
Recommended Change-out Differential Pressure
Maximum Differential (Collapse) Pressure
75 psid @ 70ºF (5.2 bar @21ºC), 40 psid @176ºF (2.8 bar @ 80ºC)
Sanitization and Sterilization
Hot water at 175ºF (80ºC) at 5 psid for 30 minutes
Media Surface Area 7.2 sq.ft. (0.67 m2) per 10 inches filter length In-line steam at 257ºF (125ºC) @ 1 psid (0.7 bar) for 30 minutes
Autoclavable at 257ºF (125ºC) for 30 minutes
Gaskets/O-rings
Silicone, Buna N, EPR, Viton, Teflon Encapsulated Viton
FDA and USP Compliance
(O-rings only)
Materials of Construction
Filter Media: tt
Outer Cage tt
Inner Core: tt
End caps: tt
Asymmetric Polyethersulfone
Polypropylene
Polypropylene
Polypropylene
All polypropylene materials comply with the requirements of
Food and Drug Administration Title 21 of The Code of Federal
Regulations 174.5, 177.1520 and 177.1630. All components meet
current USP Class VI biological tests for plastics
www.shelco.com